Current Tool I'm Loving-Fraisa Finisher

Fraisa, endmill, carbide, finisher

This past month I've been running a .500" 7-flute finishing endmill from Fraisa in 440 Stainless. I must say, the results have been exceptional. Due to the high helix of this tool, they recommend only taking .008" per pass. I've been running the book values, which suggest a spindle speed of 1985 RPM's and a feedrate of 17 inches per minute. Right out of the gate I was achieving a surface finish of 16Ra. As of part 100, we are still seeing a surface finish of 16-17Ra, and the tool hardly looks used. Keep in mind, I'm finishing roughly 31 linear inches per part. I have this in an ER32 collet, and haven't experienced any tool pull-out.

This is my first time using a Fraisa tool, but definitely not my last. They offer a wide variety of cutting tools, and you can even buy directly from them, from their website! Check them out by clicking on the link or picture above.


  • Hugo

    Thank you for sharing your info. I really appreciate your efforts and Thanks a lot for sharing a piece of wonderful information which I am looking for a longer period of time.

  • 메이저놀이터


  • شركة الصقر الدولي لنقل العفش والاثاثشركة الصقر الدولي لنقل العفش والاثاث وخدمات التنظيف المنزليةشركة الصقر الدولي لنقل العفش والاثاث وخدمات التنظيف المنزليةشركة الصقر الدولي لنقل العفش والاثاث وخدمات التنظيف المنزلية

  • 서울오피


  • 카지노사이트

Leave a comment

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.