Current Tool I'm Loving-Fraisa Finisher

Fraisa, endmill, carbide, finisher

This past month I've been running a .500" 7-flute finishing endmill from Fraisa in 440 Stainless. I must say, the results have been exceptional. Due to the high helix of this tool, they recommend only taking .008" per pass. I've been running the book values, which suggest a spindle speed of 1985 RPM's and a feedrate of 17 inches per minute. Right out of the gate I was achieving a surface finish of 16Ra. As of part 100, we are still seeing a surface finish of 16-17Ra, and the tool hardly looks used. Keep in mind, I'm finishing roughly 31 linear inches per part. I have this in an ER32 collet, and haven't experienced any tool pull-out.

This is my first time using a Fraisa tool, but definitely not my last. They offer a wide variety of cutting tools, and you can even buy directly from them, from their website! Check them out by clicking on the link or picture above.


  • Mia

    Very informative article. Such an amazing and helpful post.

  • Hugo

    Thank you for sharing your info. I really appreciate your efforts and Thanks a lot for sharing a piece of wonderful information which I am looking for a longer period of time.

  • 메이저놀이터


  • شركة الصقر الدولي لنقل العفش والاثاثشركة الصقر الدولي لنقل العفش والاثاث وخدمات التنظيف المنزليةشركة الصقر الدولي لنقل العفش والاثاث وخدمات التنظيف المنزليةشركة الصقر الدولي لنقل العفش والاثاث وخدمات التنظيف المنزلية

  • 서울오피


Leave a comment

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

You may also like

View all
Example blog post
Example blog post
Example blog post